Encardio-rite model EDI-53 series readout units is a micro-processor based read out unit which can be used with various type of sensors, like those with voltage output, current output, etc. The readout unit can display the measured parameter directly in applicable engineering units. Potentiometric and resistance strain gauge based geotechnical transducer from most other manufacturers can also be read by the EDI-53.
The readout unit is available in following variants:
Model EDI-53 digital indicator can store calibration coefficients of maximum 250 numbers of transducers. It can store either around 3600 readings from any one transducer or about 14 sets of readings from all the 250 transducers. Each reading is stamped with date and time at which the measurement was taken.
The EDI-53 digital indicator is housed in a light weight splash proof plastic moulded enclosure with weather proof connectors for making connections to the transducer and the battery charger.
Model EDI-53P
Input: Potentiometric displacement transducers with 0-2 V DC output.
Excitation voltage: 5 V DC
Model EDI-53L
Input: Resistance strain gauge bridge load cell with 0…3 mV/V output.
Excitation voltage: 5 V DC
Min. L/C input resistance: 90 Ohms Preamplifier gain 100
Model EDI-53I
Input: 4-20 mA DC current input.
Input resistance: 50 ohms
Model EDI-53UTM
Input: Uniaxial tilmeter; 0-4 V DC output
Excitation voltage: 12 V DC (nominal)
Model EDI-53ELV
Input: EL tilt meter (voltage output)
Excitation voltage: 12 V DC (nominal)
GDS has a variety of instruments for hire, these Instruments, Readouts and Dataloggers are available for product hire on a short-term (fortnightly) or long-term (monthly) basis including, but not limited to, the following:
