This jack out pressure cell has been designed to measure the stress on base slabs, diaphragm/slurry walls etc. Construction of a jack out pressures cell is a combination of a thin, flexible, round, flat diaphragm and a thick and rigid back plate. The plates are welded around the periphery leaving a very little gap between the two. The electron beam welded vibrating wire pressure sensor has been welded concentrically with the back plate and the cavity inside the sensor is filled with de-aired fluid.
The electron beam welded vibrating wire pressure sensor has been welded concentrically with the back plate and the cavity inside the sensor is filled with de-aired fluid.
| Range (MPa) | 1.0, 2.0, 3.5, 5.0, 10.0, 20.0, 30.0, specify |
| Accuracy* | ± 0.5 % fs standard | ± 0.1 % fs optional |
| Over range limit | 150 % fs of range |
| Temperature limit | -20°to 80°C |
| Thermistor | YSI 44005 or equivalent |
| Pressure pad sizes l x b (mm) | 100 x 200 | 150 x 250 | 200 x 300 | 300 x 300 |
| *Calibrated accuracy of pressure sensor | |
GDS has a variety of instruments for hire, these Instruments, Readouts and Dataloggers are available for product hire on a short-term (fortnightly) or long-term (monthly) basis including, but not limited to, the following:
